Apps, desktop toys and computer sound

Dial-up modem sounds explained: tones and handshakes

Published

The dial-up noise comes from modems, devices that send computer data over phone lines. First one places a telephone call. Then the two modems agree how to connect and test the line. The whistles, chirps and bursts of noise reveal stages of that work.

On this page

A modem’s speaker lets you hear these steps. When it falls silent, the data connection can carry on.

Mac OS 9 Remote Access shows a connected dial-up session at 33,600 bits per second.
Mac OS 9’s Remote Access connected at 33,600 bps in Jeff Geerling’s 2026 Pi ISP experiment. Image: Jeff Geerling, screenshot; Apple, Mac OS 9 interface. Source.

1. Dialling reaches the other modem

The familiar push-button telephone sounds are DTMF dialling tones. Each digit combines two sound frequencies, or pitches. After the other modem answers, the modems begin to prepare a data connection.

William Termini’s recording account describes a November 2008 NetZero attempt that failed. Add timestamps to the listening map wherever you hear a clear transition.

2. Tones identify capabilities and prepare the line

Oona Räisänen’s annotated spectrogram plots the sound frequencies over time and labels which modem sends each signal. The modems first agree which connection methods both can use. The answer tone tells phone-network equipment to turn off echo suppression. Phase changes, shifts in the sound wave, address echo cancellation.

Those network tools reduce echoes in voice calls but can interfere with a modem signal. The repeated tones help prepare the line for data.

In the spectrogram, time runs left to right and frequency runs bottom to top. A narrow horizontal band shows one steady frequency. Several bands or a broad patch show a more complex signal.

3. Training measures the channel

The modems send known test patterns to measure how the phone line changes their signals. Each can then adjust to that line. This testing, called training, creates much of the changing sound in the handshake.

The ITU’s V.90 recommendation sets top rates of 56,000 bits per second downstream (to you) and 33,600 upstream (from you). It uses a pair of digital and analogue modems. The two ends agree the speed for each call; “56k” is the standard’s top download rate.

At that top rate, 56,000 divided by eight equals 7,000 bytes per second. A 70,000-byte file would take ten seconds before allowing for extra data used to manage the transfer and other delays. Small images and compact pages reduced the wait.

Why the sound stops

USRobotics’ AT command reference documents three speaker settings:

Command Speaker behavior
ATM0 Off
ATM1 On until the connection forms
ATM2 On continuously

With ATM1, the modem switches its speaker off once it connects. It still exchanges data. These commands belong to the named USRobotics command set; check your modem’s manual before changing its speaker settings.

Read a simpler signal first

Play the original two-tone study, then open it in an audio editor’s spectrogram view. The separate 700 Hz and 1,200 Hz tones form single bands; the combined tones form parallel bands. Find those bands in the editor before returning to the more complex historical handshake.

The download pack includes the WAV sound file, listening map and creator note. Use the map to compare when two modem recordings move from dialling to agreeing a method and testing the line. Different equipment and line conditions can change the sequence.

For musical startup sounds and message alerts, continue with old internet sounds. Those sounds announce an event; the modem’s sounds help make the connection.